Skytech FK-180-ESC
REV 2-26-18 Page 1
Fan
Ground Wire
Power Wires
Electronic
Fan Speed Control
HI
MH
ML
LO
OFF
FAN
SPEED
TEST
FAN TURNS ON TO
SELECTED SPEED
7 MINUTES AFTER MAIN
FLAME IS TURNED ON
FAN TURNS OFF
12 MINUTES AFTER MAIN
FLAME IS TURNED OFF
TEST WILL TURN FAN
ON HIGH AS LONG AS
BUTTON IS PRESSED
2 - 1/4” Female
Connectors
1 - 1/4” Female
Connector
1- 1/4” Ring Connector
1- Polorized Plug
1 - 3/16” Piggyback Connector
1 - 1/4” Male Connector
Model: FK-180-ESC
INSTALLATION AND OPERATION INSTRUCTIONS
I
NTRODUCTION
1/4” Female Connectors
1
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
2
3
4
The FK-180-ESC Fan Kit has been designed to circulate room air through many hearth products in the industry. The FK-
180-ESC operates on 120VAC, 60Hz power. The fan dimensions are 12-3/4” W x 4-3/8” H x 4-5/16” D.
Power must be provided through an approved factory installed junction box from the hearth product’s manufacturer.
A speed control (FK-ESC) is provided with the Fan Kit System to adjust the air output. The speed control will turn ON the
fan automatically 7 minutes after the main flame has been turned ON and turn the fan OFF 12 minutes after the main
flame has been turn OFF. There are four speeds, Hi, Medium Hi, Medium Lo, Lo and OFF. You can manually adjust the
speed by pressing the FAN SPEED button on the FK-ESC. The FK-ESC will remember the last setting used and remain
on that setting until changed.
Compare the contents of your package with the figure drawings below.
1. F-180-1 Fan with two leads and a ground wire
2. FK-ESC (speed control)
3. Jumper Wire (used for IPI valves only)
4. Jumper Wire (used to jump power strip when applicable)
