Quantum TC2201E Installation Instructions
Document 81-81449-01 A01
July 2005
12
Connecting the TC2201E
Figure 11 TC2201E
Ethernet port
Ethernet Management port
RS-232 Serial
Connection
0
The 3-pin connector on the back panel of the TC2201E provides a serial port
that is compatible with RS-232 signaling levels. The TC2201E is designed to
communicate with a terminal or any operating system utilizing a terminal
emulator. The baud rate, data bits, stop bits, parity, and flow control of both
the TC2201E and the host system must use the same settings.
Figure 12 TC2201E Serial
Port
Serial port
Setting Up Serial Port
Communications
0
Leave the TC2201E turned off until you have set up the serial port
communications on your host computer, unless serial I/O was previously
established and is currently running.
The TC2201E is designed to communicate with a terminal or any operating
system utilizing a terminal emulator. For example, Windows 9x, NT 4.0, or
Windows 2000 operating systems can use Hyper terminal. Be sure the baud
rate, data bits, stop bits, parity, and flow control are set correctly.
To set up serial communications with the TC2201E:
1
Leave power to the TC2201E turned off until you have set up the serial
port communications on your host terminal.
2
Plug the serial cable into one of the host computer’s serial ports (COM1 or
COM2), and then plug the other end of the serial cable into the TC2201E’s
serial port
Note:
A 3-pin serial cable is included in the shipping container for
the TC2201E.
.
