Procedure
Quantum Smart-1 6000-L/6000-XL Appliances Replacing SAN Cards | 8
Disconnect the safety ground wires from the DC PSUs.
Disconnect the DC power connectors from the DC PSUs.
6. Remove the hook-and-loop straps that hold and secure the system cables, if they interfere with the
PSU removal.
7. Remove any other attached cables, if necessary.
8. Remove the appliance from the rack. See the
Installing the Quantum Smart-1 6000-L/6000-XL
booklet for illustrated installation procedures.
9. Put the Electrostatic Discharge (ESD) grounding strap on your wrist and attach the other end to a
grounding point.
10. Remove the appliance cover:
a. Use a flat or a Phillips head screwdriver to rotate the latch release lock counter-clockwise to the
unlocked position.
b. Lift the latch.
c. Slide the cover back.
The tabs on the cover should disengage from the guide slots on the appliance.
d. Hold the cover on both sides and lift the cover away from the appliance.
Replacing the Bracket on a SAN Card
The Emulex LPe31002 Dual, 16GFC Host Bus Adapter SFP+ is shipped with a short and long bracket.
n
If the long bracket is attached to the SAN card, no replacement is necessary and you can continue to
install the card in the riser.
n
If the short bracket is attached to the SAN card, follow the instructions below to replace it with the long
bracket supplied in the carton.
Note - The optical transceivers on the SAN card are delicate.
n
Remove and install the transceivers carefully.
n
Use ESD (Electrostatic Discharge) precautions such as an antistatic floor mat and an antistatic wrist
strap.
