28
www.quantumrehab.com
Quantum 610
V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat, you
can change the seat height either through the controller or through a
toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See
figure 26.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run more
than a few seconds after the mechanism
reaches the top or bottom limit.
NOTE: For more information on operating the power el-
evating seat through the controller, contact your Quantum
Rehab Specialist.
WARNING! The power elevating seat option is
intended for use on a level surface only. Never
raise the seat from its lowest position on an
inclined surface. Failure to heed this warning
can result in the power chair tipping over and
causing injury.
WARNING! Never raise the seat from its low-
est position when operating your power chair
on bumpy or uneven surfaces. Failure to heed
this warning can result in the power chair tip-
ping over and causing injury.
WARNING! Never raise the power elevating seat
while your power chair is in the freewheel
mode.
WARNING! Always fasten the positioning belt
when operating the power elevating seat.
NOTE: The power elevating seat option is equipped with a
system that reduces the speed of the power chair by one half
when the seat is elevated more than 2.5–5 cm. Always check
to be sure this system is operating properly before using your
power chair.
Figure 26. Power Seat Toggle Switch
