Quantum 610
www.quantumrehab.com
25
V . C O M F O R T A D J U S T M E N T S
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut anticlockwise one-quarter
or one-half turn.
Foot Platform Angle
You can adjust the angle of the foot platform with a hex key.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew. See
figure 19.
2. Turn the setscrew anticlockwise to raise the front of the
foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Turn the rear shroud fasteners anticlockwise one-quarter
turn. See figure 6.
3. Remove the rear shroud.
4. Unplug the controller connector(s) from the power base.
5. Cut the wire tie(s) securing the controller cable to the
armrest.
6. Loosen the setscrews in the mounting block. See
figure 21.
7. Move the controller mounting block and controller to
the other armrest and tighten the mounting screws.
NOTE: For contour seats, loosen the setscrew on the
underside of both armrests, transfer the controller,
and tighten the setscrews. See figure 20.
8. Route the controller cable to the back of the power
base and plug in the controller.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the controller connector(s) into the power base.
11. Reinstall the rear shroud and tighten the fasteners.
Figure 20. Underside of Armrest (Contour Seat)
SETSCREW
Figure 19. Underside of Foot Platform
Figure 21. Mounting Block Controller Installation
MOUNTING
SCREWS
SETSCREWS
MOUNTING
BLOCK
SETSCREW
