Quantum QS-500 Series, Installation And Operation Manual

Page: 52 / 56

Model QS-500 Tubestand
A complete series of inspections and functional checks was conducted at the
time of installation to insure proper operation of the system. The following in-
spection and adjustment procedures are recommended to maintain the system
in its original operating condition.
Perform Daily:
•
Visually inspect for wear and cleanliness.
• Clean Tubestand exterior surface.
Perform Every Six Months:
•
Check for evidence of loose hardware or loose wires.
•
Check all bearings and bearing surfaces for cleanliness and corrosion.
•
Clean Bearing Tracks, Floor Track, and Top (ceiling/wall) Track.
•
Conduct a general inspection for worn or damaged parts.
• Check for proper counterbalancing and smoothness of vertical (up/down)
Tubestand motion.
REPLACEMENT PARTS AND ORDERING INFORMATION
Table 2 provides a list of replaceable parts for the Tubestand. Figures 22
through 26 show the locations of the replaceable parts in the system.
ORDERING INFORMATION
To order replacement parts for the Tubestand, contact the Service Department
at:
Quantum Medical Imaging, LLC
2905 Veterans Memorial Highway
Ronkonkoma, New York 11779
Phone: (631) 587-5800
Chapter 5 Maintenance
40