Quantum Q-Logic 3, Programming Manual

Page: 5 / 44

5
SETUP
Startup Configuration — User Entry Point
User Entry Point is what screen the electronics will start on
when powering up the power chair.
1. Parameter Settings/Program Adjustments
2. Startup Configuration
3. User Entry Point: From the drop-down, choose one of
the following options:
„
Home
„
Drive 1, 2, 3, 4
„
Input Device Selection
„
Auxiliary
„
Seat
„
Last used
Programming Clinic Mode
Clinic Mode allows a clinician or an ATP to quickly perform
an initial setup of a demo chair without a programmer. Clinic
Mode needs to be Enabled in the programming first.
1. Parameter Settings/Program Adjustments
2. Startup Configuration
„
Enable Clinic Mode
„
Once Clinic Mode is enabled, power off the power
chair
„
Power up the power chair by pressing then holding
the On switch for 5+ seconds.
The first screen will allow you to choose the mode you want
to use. 1-Switch Scanner is a programmable feature, not a
module. Choose which type of device the specialty control is.
1. Choose how the device will be programmed (i.e. if you
have a 3-Switch Head Array plugged into the Enhanced
Display of the power chair).
2. On the first screen, choose Enhanced Display.
3. On the second screen, choose Head.
4. On the third screen, choose 3-Switch Head.
Adding Provider Information
A Provider can add their contact information in a Q-Logic 3
Enhanced Display or Hand Control. The serial number of the
power chair is automatically entered as the unit is being built.
1. Parameter Settings/Program Adjustments
2. System
„
Miscellaneous (Click on Provider Info Line 1, enter
the first line of information, making sure to press the
enter key once complete).
„
Repeat steps for remaining Provider Info lines,
making sure to press the Enter key after each.
Accessing Provider Information
To see the changes made to the Provider information, follow
these steps with your Enhanced display or Hand Control.
1. Parameter Settings/Program Adjustments
2. System
„
From the Home screen make a left input device
command.
„
From the Settings screen, make another left input
device command.
„
Highlight System Information and give a right input
device command.
„
Highlight Provider Information and make a right
input device command.