Quantum Q-Logic 3, Programming Manual

Page: 15 / 44

15
SWITCHES
Programming 4 Switch — Changing Profiles
with Standby Select
Standby Select can be set to a certain length of time. When it
expires, the power chair goes into a standby mode. Standby
mode then reverts back to the home screen, where the end
user can choose what part of the chair they want to go into,
such as Settings, Drive or Seat.
1. Parameter Settings/Program Adjustments
2. Enhanced Display or SCIM
3. Standby Select
„
Enabled
4. Standby Select Timeout
„
Use the Slide Bar in the time out box to set the time.
The Standby Seat and Aux Timeouts should always be set
to Enabled; otherwise, the person will not have any way to
return to their drive profile from a seat or aux profile.
Programming 4-Switch — Menu Settings
For each direction a specific menu navigation is assigned.
These can be changed for an end user who has an easier
time accessing one switch over another.
1. Parameter Settings/Program Adjustments
2. Enhanced Display
3. Menu Settings
4. Menu Navigation Mode can be set to:
„
Manual: Requires a command to move to the next
item.
„
Auto Repeat: Will change from one time to the next
as long as the button is pressed.
„
Auto Change: Will change from one item to the next
automatically. The speed of the scrolling is controlled
by Menu Navigation Timing.
5. Menu Navigation Timing: Will change the time.
Programming 4-Switch — List Navigation
The List Navigation Inputs will allow programming for each
direction. The system is designed to allow customization
based off the movements of the end user if set to manual.
Below are the options:
1. Scroll Up (moves upwards through the list)
2. Scroll Down (moves downward through the list)
3. Select (selects the highlighted menu entry)
4. Back Up (returns to the previous menu)
5. Inactive (Disables the Command)
Programming 3-Switch
1. Parameter Settings/Program Adjustments
2. Enhanced Display or SCIM
3. Input Configuration
„
From the drop down, scroll and select 3-Switch.
„
The unit will go into Programming Mode
„
Click on the arrow next to Programming Mode
to reset the power chair to System Ready.
See page 33.
Programming 3-Switch — Toggle Command
1. Parameter Settings/Program Adjustments
2. Enhanced Display
3. 3-Direction Arrow Toggle Settings
„
Toggle Command: When enabled, uses the forward
command to toggle between forward and reverse.
„
Toggle Command Time: Can be programmed via
slide bar or by teaching the toggle command (end
user gives the command themselves).
„
Latch Toggle Auto Flip: If Latch Forward is set
to Enabled, this will flip the arrow form forward to
reverse automatically when the unit starts to drive..
The next touch of the switch will stop the chair.
„
Toggle While Driving: When Enabled, the end user
can change from forward to reverse while driving.
If disabled, the power chair will need to come to
a complete stop before adjusting from forward to
reverse.
Programming 3-Switch — Device Double
Command Programming
Device Double Command allows the end user to give either
a double left or double right command on their specialty
controls. This will change the mode.
1. Parameter Settings/Program Adjustments
2. Enhanced Display or SCIM
3. Device Options/Timing
„
Device Double Command: From the drop down
menu. Enable Left or Enable Right can be selected.
Programming 3-Switch — Double Command
Timing Programming
Double Command Time is the time the end user has to
provide a double command.
There are two ways this can be accomplished.
1. Parameter Settings/Program Adjustments
2. Enhanced Display or SCIM
3. Device Options/Timing
„
Double Command Time can be programmed by
using the slide bar.
„
Teach Double Command allows the end user to
give the command they can comfortably do when
the Start icon is pressed. That time can be captured
and set as the Double Command Time.
Programming Mode