Quantum Q-Logic 3, Programming Manual

Page: 25 / 44

25
SEAT
Seat Programming — Setting Pretilt
If a end user requires a certain degree of tilt or recline for
postural support (gravity assisted positioning), setting a
pretilt to the angle desired will help.
Also note to ensure the pretilt angle does not interfere with
transfers.
Depending on which Econ you are programming with, follow
the screen shot for numbers. Instructions are on the following
pages and match up with the numbers on the screen shot.
Setting a Seat Pretilt can only be completed using the
Econ-W Programming Stations.
Seat Programming—Setting Pretilt
1. Click/tap on Add New Restriction.
2. Click/tap on the drop down at the top of the blank
restriction at the bottom of the page. Select Actuator
Restriction.
3. Set the Restriction to Forward Restricted.
4. Set the Actuator Type to Actuator Tilt for a pretilt or
Actuator Recline for a pre-recline.
5. Click on the + sign and choose Condition 1.
6. Set drop down to Inclination Condition.
7. Use the slide bar to select your pretilt or pre-recline angle
8. Click on the drop down and select Inclination Seat
Recline.
9. Set Threshold to Threshold Less Than.
If your power chair is equipped with a reclining seatback,
do not attempt to negotiate inclines with the seat in a
reclined position. Do not attempt to negotiate obstacles
with the seat in a reclined position unless an attendant is
present to help stabilize the chair. Failure to heed these
precautions may result in the power chair tipping over.
WARNING!
Seat Programming — Setting Pretilt
(Screenshot Econ-W)
1
2
4
5
6
8
9
3
7
Figure 12. Seat Programming — Setting Pretilt (Screen
shot Econ-W)