Quantum PX720 Unpacking and Installation Instructions
Document 6444602-04 A01
March 2005
Installing the Quantum PX720 Library
23
5
Repeat
step 4
until the front is level.
6
Repeat
step 3
and
step 4
for the left edge, back edge, and right edge of the
library.
7
Recheck the level on all top edges.
8
If necessary, repeat
step 3
and
step 4
until all four top edges of the library
are level.
The unpacking is complete.
Installing the Quantum PX720 Library
0
Installing the Quantum PX720 library consists of the following steps:
•
Cabling the Quantum PX720
•
Connecting the Cluster Controller Ethernet Cables
•
Cabling a SCSI PX720 Library
•
Cabling a Fibre Channel PX720 Library
•
Loading the Tape Cartridges
•
Initial Configuration
Cabling the Quantum
PX720
0
After the Quantum PX720 is in its final location, the tape drives and robotics
controller must be connected to the backup host system(s). The cluster
controllers must also be connected with Ethernet cables. The PX720 supports
both SCSI and Fibre Channel host interfaces.
Refer to the appropriate section for your PX720 installation:
•
Connecting the Cluster Controller Ethernet Cables
•
Cabling a SCSI PX720 Library
•
Cabling a Fibre Channel PX720 Library
Connecting the Cluster Controller Ethernet Cables
0
To connect the Cluster Controller Ethernet cables:
1
Open the back door of the Quantum PX720 to gain access to the tape
drive cluster controllers (see
figure 25
on page 26).
2
Refer to
table 1
and
figure 24
for the tape drive cluster Ethernet
connections.
