Quantum PX506 and PX510 Unpacking and Installation Instructions
Document 81-81338-01 D01
June 2005
Installing the Library
27
4
Secure the back of the library to the rack with two mounting clamps and
and two Allen screws on each clamp. The mounting clamps are oriented
differently depending on the depth of the rack (see
figure 20
).
5
Secure the mounting clamps to the rack rails with two PHILLIPS screws
on each side (see
figure 20
).
Figure 20 Securing the
Back of the Library
6
Install the power supplies previously removed. Tighten the captive
screws with a flat blade screw driver.
7
To install the tape drives into the library:
a
Remove the tape drive cover plates by loosening the captive screws
securing the plate to the library chassis with a flat blade screwdriver
(see
figure 21
).
Note:
If the rack depth is 27 to 30 in., the long portion of the clamp is
mounted to the back. If the rack depth is 30 to 36 in., the long
portion is mounted to the front.
Allen
screws
Ba
ck
of
ra
ck
Long
portion
PHILLIPS
screws
PX506 shown
