Installing the Internal LTO-4 Half-Height Tape Drive
5
LTO-4 Half-Height Tape Drive
Figure 3 Internal Tape Drive
Mounting Hole Locations
Connecting the Internal
Drive Interface and DC
Power Cables
0
As shown in
figure 4
, the rear panel of the internal LTO-4 Half-Height Tape Drive has
connectors for:
• A 7-pin 1x SATA-style serial-attached SCSI (SAS) interface cable
• A serial library interface cable
• The internal drive DC power cable
Figure 4 Internal Drive
Interface and DC Power
Connectors
Connect the interface and DC power cables to the internal drive as follows:
1
Verify that the system is shut down and the AC power cord is disconnected from the
facility AC power receptacle.
2
If you are installing the internal LTO-4 Half-Height Tape Drive in a tape library
system, connect the RS-422 serial interface cable to the serial library port on the back
of the drive. (The serial library port is not used in workstation or server systems.)
3
Connect the internal drive DC power cable to the DC power connector on the back of
the drive.
4
Reinstall the system cover.
5
Reconnect the system AC power cord to the facility AC power receptacle.
Lower mounting holes
Upper mounting holes
Serial library port
DC power connector
7-pin 1x SATA-style SAS connector
