![background image](http://html1.mh-extra.com/html/quantum/dxi6900/dxi6900_installation-manual_3781111062.webp)
Performing Initial Configuration
Quantum DXi6900 Installation Guide
62
The GUI Administrator password can be up to 32 characters. Alphanumeric characters and
special characters are allowed.
c. Enter the new password again in
Confirm New Password
.
6. Create a new password for the Service SSH (ServiceLogin) user account:
a. Enter a
New Password
.
Additional Information
l
The Service SSH password can be up to 20 characters. Alphanumeric characters and
special characters are allowed.
l
The Service SSH (ServiceLogin) password is also used for iDRAC/IPMI login.
l
The
Access Control
page in the
Remote Management Console
allows the Service SSH
(ServiceLogin) and iDRAC login to be disabled.
b. Enter the new password again in
Confirm New Password
.
7. Click
Next
to continue.
The
Network
)
IMPORTANT - READ BEFORE CONTINUING
Steps 8-12 below provide an example of configuring network settings on the DXi6900. In this
example, the DXi6900 is configured as follows:
l
All Ethernet ports are configured as individual devices (Not Bonded).
l
A single network interface with one IP address is configured for eth1.
l
All traffic types (management, data, and replication) travel over the single network interface.
l
All other settings are at default values.
The actual network settings you will enter depend on the configuration of your company’s network
and may differ from those below. Work with your network administrator to determine the correct
settings for integrating the DXi6900 into your company’s network.
If you set up the DXi6900 using the example below, you can always change the network settings as
needed at a later time. For more information, see the “Network” section in the Quantum DXi6900
User’s Guide (6-68159).