![background image](http://html1.mh-extra.com/html/quantum/dxi6900/dxi6900_installation-manual_3781111036.webp)
Installing the DXi6900 System in the Rack
Quantum DXi6900 Installation Guide
36
Caution:
Before proceeding, ensure that all hard drive latches are completely closed. Quantum
recommends that you do not remove the hard drives from the chassis. If they have been removed for
any reason during or after the installation, you must install the hard drives in the same position in which
they were removed.
1. Align the Array or Expansion module with the rails, and then slide the module into the rack (see
).
2. Use a 10-32 x 3/4 in. SEM screw with washer at the bottom hole on each side of the Array or Expansion
module’s front panel to secure the module to the rack.
3. Install the end caps on either side of the module by inserting the top of the end cap first and then
snapping the bottom into place.
Install the end cap with the indicator icons to the left of the module, and install the end cap with the drive
numbers to the right of the module.
Note:
To remove the Array or Expansion module, remove the screws and slide the module out of the
rack.