Connections: Single Drive | C4
C4
Connections: Single
Drive
The Super DLTtape drive performs best when it is the only
device connected to the SCSI bus. If the tape drive is the only
SCSI device you intend to connect to the SCSI bus, follow
these steps:
1.
Make sure the host computer and all peripheral devices
are powered off.
!
Never connect the tape drive while the host system or
peripheral devices are powered on.
2.
Connect a terminator to the upper SCSI connector on the
back of the tape drive.
!
You must terminate the SCSI bus. The SCSI controller
terminates one end, while a terminator on the tape drive
terminates the other end.
3.
Connect one end of the SCSI cable to the lower
connector on the back of the tape drive.
4.
Connect the other end of the SCSI cable to the SCSI
connector on the host computer.
!
For optimum performance, the Super DLTtape drive
should be the only device connected to the SCSI bus.
For more information about connecting the tape drive, refer
to the
SDLT 220 and SDLT 320 Product Manual
.
3
Terminate upper
SCSI port.