C3 | Setting the SCSI ID
C3
Setting the SCSI ID
This section describes how to set the SCSI ID on the tabletop
tape drive. For information about setting the SCSI ID on an
internal tape drive, refer to the
SDLT 220 and SDLT 320
Product Manual
.
Each device connected to a SCSI bus must have a unique
SCSI ID number. The factory preset SCSI ID is 3 for the
tabletop tape drive and 5 for the internal tape drive. Ensure
that your tape drive’s SCSI ID is unique on your SCSI bus.
!
If the drive is the only SCSI device, leave the SCSI ID set
to the default setting.
!
Do not use a SCSI ID of 7. This setting is typically
reserved for the SCSI controller.
You can change the SCSI ID using the push-button switch
on the back of the drive. Press the switch buttons above or
below the number display with the point of a pencil to
increase or decrease the ID number.
3
3