Chapter 4: SCSI Commands
4-88
July 2004
81-81276-01 Rev A01
If any READ command cannot be completed successfully, the tape drive returns a CHECK
CONDITION status. Further commands should attempt to move past the error and complete
successfully.
4.13 READ BLOCK LIMITS (05h)
The READ BLOCK LIMITS command tells the tape drive to return its limits for block length. The
tape drive sends this information during the DATA IN phase of the command. The command does not
reflect the currently selected block size, only the available limits; MODE SENSE returns the current
block size.
Figure 4-58.
READ BLOCK LIMITS (05h) Command Descriptor Block — Data Format
Figure 4-59.
READ BLOCK LIMITS (05h) — Data Format
Bit
Byte
7
6
5
4
3
2
1
0
0
Operation Code (05h)
1
Logical Unit Number
Reserved
2 - 4
Reserved
5
Unused
Reserved
Flag
Link
Bit
Byte
7
6
5
4
3
2
1
0
0
Reserved
Granularity
1 - 3
(MSB)
Maximum Block Length
(LSB)
4 - 5
(MSB)
Minimum Block Length
(LSB)
Summary of Contents for DLT1/VS80 SCSI
