Quantum ACL 4/52, Operator'S Manual

Page: 46 / 68

Chapter 2 Operating Procedures
Operating Procedures Using the Menu Mode
30 ACL 4/52 Operator’s Guide
Operating Procedures Using the Menu
Mode
2
This section contains procedures for entering and exiting the control
panel menu mode and instructions for executing the operator tasks
listed below:
• Setting or changing the library or tape drive SCSI addresses
• Defining the state of the library after the power-up sequence has
completed
• Enabling or disabling the automatic drive cleaning option
• Enabling or disabling the retry operation option
• Setting or changing the language displayed in the SDA
• Adjusting the SDA contrast level
• Unloading a tape cartridge from a specific drive
• Directing cleaning tape cartridges to specific drives for cleaning
• Performing the initial loading of the library
• Displaying the status of the library
• Performing an inventory of the library
Entering the Menu
Mode
2
To enter the menu mode:
1 Press the control panel STANDBY button and verify the SDA
shows
System Off-line
.
2 Press the SELECT button to enter the menu mode.
3 Verify the following is displayed in the SDA:
Exiting the Menu Mode
2
There are two different ways to exit from menu mode.
The fast method:
1 From anywhere in the menu, press the SELECT and
↑
or
↓
buttons, simultaneously and verify that
System Off-line
is
displayed in the SDA.
M e n u :
C o n f i g u r a t i o n