Quantum 980, User Manual, Page: 15 / 116

980 User Guide
– HDMI HDCP 2.2 Compliance
Rev. A2
Page 15 October 15, 2014
3 HDMI HDCP 2.2 Source Compliance Tests
This chapter describes how to use the optional HDMI HDCP 2.2 source compliance test feature of the 980 HDMI
Protocol Analyzer module. Please note you will have to purchase the HDMI HDCP 2.2 Source Compliance Test
option in order to run these tests.
Note : You can now select addition formats for testing on an individual test basis. This enables you to run a
particular source test on a format or formats that are not specified in the CTS.
The 980 supports the following test sections in the HDMI HDCP 2.2 Compliance Test specification:

Transmitter Downstream w/Receiver) w/HDMI Capable Receiver

1A-01: Regular Procedure: With previously connected Receiver (with stored Km)

1A-02: Regular Procedure: With newly connected Receiver (without stored Km)

1A-03: Regular Procedure: Receiver disconnect after AKE_Init

1A-04: Irregular Procedure: Receiver disconnect after Km

1A-05: Regular Procedure: Receiver disconnects after locality check.

1A-06: Regular Procedure: Receiver disconnects after Ks

1A-07: Regular Procedure: Receiver sends REAUTH_REQ after Ks.

1A-08: Irregular Procedure: Rx Certificate not received.

1A-09: Irregular Procedure: Verify Receiver Certificate.

1A-10: Irregular Procedure: SRM.

1A-
11: Irregular Procedure: Invalid H’.

1A-12: Irregular Procedure: Pairing Failure.

1A-13: Irregular Procedure: Locality Failure.

Transmitter w/ Downstream Repeater

1B_01 Regular Procedure: With Repeater.

1B_02 Irregular Procedure: Timeout of Receiver ID list.

1B_03 Irregular Procedure: Verify V'.

1B_04 Irregular Procedure: MAX_DEVS_EXCEEDED.

1B_05 Irregular Procedure: MAX_CASCADE_EXCEEDED.

1B_06 Irregular Procedure: Incorrect seq_num_V

1B_07 Regular Procedure: Re-authentication on HDCP_HPD.

1B_08 Regular Procedure: Re-authentication on REAUTH_REQ.

1B_09 Irregular Procedure: Rollover of seq_num_V

1B_10 Irregular Procedure: Failure of Content Stream Management
3.1 Workflow for running the HDMI HDCP 2.2 Source Compliance Tests
The following is the high level workflow for running the HDMI HDCP 2.2 Source Compliance Tests. This workflow
assumes that you have powered up the 980 and established an Ethernet session with the 980 as described in
Connection for 980 GUI Manager and 980 .
The following is the high level workflow for running the HDMI HDCP 2.2 Source Compliance Tests.
1. Connect the source device under test to the 980 HDMI Protocol Analyzer module via HDMI.
2. Activate HDCP 2.2 in the source device under test.
3. Set the monitor mode properly to HDMI and Sink Emulation.
4. Enable HDCP 2.2 in the 980 HDMI Protocol Analyzer module.
5. Complete (or load an existing) Capabilities Declaration Form (CDF) for the device under test using the CDF
Entry panel.
6. Select the tests that you wish to run from the Test Selection panel.