Testing the QNET Physics and Dynamics
STEP 5
I
H
D
F
E
Click on the STOP
button to stop running
the VI.
Click on the
white arrow
to run the VI.
Make sure that the Pulley
Encoder graph is also
showing a change in angle
when the pulley is spun
back and forth.
1. Remove the sliding mass from its storage
location on the support bar, and place it
next to the electromagnetic as shown.
2. Press the Lock Mass button on the VI,
and check that the mass becomes firmly
attached to the magnet.
Press the catapult arm down until it latches
against the magnetic arm lock. Make sure
that it is firmly held in place. Press the FIRE
button and check that the Arm Speed graph
shows a change in the arm angle.
Select the device name to match your
NI ELVIS II device as shown in the NI
Measurement
&
Automation Explorer
in the
Device
control.
A
B
Make sure your PC,
NI ELVIS II, and QNET
board are powered ON.
Open the
Quick Start
folder from the
Physics and Dynamics
folder in the QNET Resources. The QNET Resources are available
for download from www.ni.com/qnets.
G
C
Open the LabVIEW Virtual Instrument (*.vi)
found under the
Quick Start
folder
