Review the following recommendations before contacting Quanser’s technical support engineers
TROUBLESHOOTING
STILL NEED HELP?
For further assistance from a Quanser engineer, contact us at [email protected]
or call +1-905-940-3575.
The +5 LED on
the QNET Physics
and Dynamics
board is not lit.
•
Ensure that the PCI connector on the QNET board is properly connected to the female
connector on the NI ELVIS II unit.
•
Check that the system power switch, located on the back panel of the NI ELVIS II unit,
and the prototyping power switch, situated on the top of the NI ELVIS are ON.
•
If the +5V LED is still not lit, then the +5V fuse on the Protection Board of the NI ELVIS II
has been triggered.
See the Protection Board Fuses in the NI ELVIS II User Manual.
©2015 Quanser Inc. All rights reserved. NI ELVIS is a trademark of National Instruments. QNETs were developed by Quanser exclusively for National Instruments.
V1.1
LEARN MORE
For full range of QNETs visit www.ni.com/quanser.
For advanced control tools for teaching and research, visit www.quanser.com
Register your QNET board at https://www.qnetregistration.com to recieve regular product updates.
Expand your lab using other QNETs for NI ELVIS
• QNET DC Motor
• QNET Rotary Pendulum
• QNET VTOL
• QNET HVAC board
• QNET Mechatronic Actuators board (NEW for 2015)
• QNET Mechatronic Sensors
• QNET Myoelectric
