G
Power on the NI ELVIS II using the power switch on the back
of the unit. The
READY
and
ACTIVE
LEDs on the top NI ELVIS II
panel should briefly light, and the
READY
LED stays on.
Slide the PCI
connector at
the back of
the QNET
board into
the female
connector on
the NI ELVIS II.
Place the handle
on the front of
the QNET board
over the bracket
located on the
front of the NI
ELVIS II.
Using the screws and hex key provided,
anchor the QNET board to the ELVIS II
in the locations indicated.
Connect the NI ELVIS II
power supply to the back
panel of the NI ELVIS II.
Use the NI ELVIS II USB cable
to connect the NI ELVIS II
Unit to your computer.
E
F
A
Ensure that the NI ELVIS II power switch is in
the OFF position.
PC
C
B
D
H
Ensure that
the +5V LED
on the QNET
board is lit.
Power on the QNET Physics and
Dynamics board by turning the NI
ELVIS II prototyping board power
switch. The
POWER
LED next to
the switch should light up.
I
Setup Hardware
STEP 4
To setup the complete QNET Physics and Dynamics, please read the following instructions carefully. For full details, see
the QNET Physics and Dynamics User Manual.
