Quality Craft M850P-26FDC, Instruction Manual

Page: 9 / 13

9
M A I N T E N A N C E
O/I
: Press this button for main power and
flame effect. The indicator light will turn on.
See below for other control switches.
1250W:
For heat function - Press this switch
while the O/I switch is in the ON position.
The indicator light will turn ON.
TEMPERATURE CONTROL:
To adjust the
temperature to your individual require-
ments, turn the temperature control dial to
the right (clockwise) to increase the desired
temperature and to the left for lower tem-
perature. This temperature control dial can
only be used while the O/I switch and 1250W
switch are in the ON position.
NOTE:
When the O/I switch is turned off, the
heater functions will stop even though the
switches may be in the ON position.
MAINTENANCE
WARNING:
Disconnect power and unplug the power
cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid
the accidental burning of the skin.
RISK OF FIRE: DO NOT EXCEED
THE RECOMMENDED BULB
WATTAGE.
REPLACING THE FLAME
EFFECT LIGHT AND
LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of
fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 X 40W Type B-10 bulb
under log-set bed.
Step 3: Loosen and remove the burnt out
bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2
larger screws into the top left corner hole
and bottom right corner holes as shown
in the diagram. Secure the 10 smaller
screws into the remaining holes. Make
sure the screws are in the correct holes
and have been tightened.
Step 5: Plug in the unit.