POWER PRODUCTS LLC.
10.
STARTING CHECKLIST
IMPORTANT: Do not start the unit until it has been
completely assembled. Before switching on the unit, always
check the oil.
Check Machine before Use
Check the safety condition of the device:
1. Check the machine for leaks.
2. Check the machine for visual defects.
3. Check that all parts of the machine have been securely
fitted.
4. Check that all safety devices are in proper condition.
!
WARNING!
Do not operate this machine if you have
found any faults. To operate this machine with faults
could result in serious injury. Make sure to replace
faulty parts before using the machine again.
Adjusting the Harness
Check the safety condition of the device:
1. Check the machine for leaks.
2. Check the machine for visual defects.
3. Check that all parts of the machine have been securely
fitted.
4. Check that all safety devices are in proper condition.
Single-strap
Shoulder Harness
Quick-release
Latch
Balancing the Multi-tool on the
Shoulder Harness
1. Hang the machine on the harness hook, and see how it
balances.
2. Adjust the shoulder strap (8), the harness attachment on
the engine extension tube and the shaft handle (7) so the
attachment head balances at the required height.
STARTING THE MULTI-TOOL
Starting the product depends on whether the engine is cold or
warm.
!
WARNING!
The recoil starter can be damaged by
abuse.
- Never pull the starter cord to its full length.
- Always engage the starter before cranking the engine.
- Always rewind the starter cord slowly.
Once the machine has been correctly assembled and setup for
operation, start the engine as follows:
1. Press the fuel primer bulb (6) 8 times or until no air bubbles
are flowing through the primer bulb.
2. Turn the engine switch (9) in the on position
3. Move the carburettor choke lever (2) to the ‘on’ position.
4. Pull the recoil starter handle (4) slowly until it engages, then
pull briskly. Repeat this step until the engine fires and starts
running.
5. Once the engine is warmed up after a few seconds, adjust
the choke lever (2) back to the ‘off’ position.
6. To control the engine speed, hold down the safety catch
(10) on the shaft handle (11) and pull the throttle trigger (12).
When re-starting a warm engine (that has already been
running), choke activation is not required.
NOTE: 4 Stroke Engine requires engine oil.
Check level before every operation.
