QuadTech Sentry 10 Plus, Instruction Manual

Page: 8 / 85

Page 8 of 85
Specifications (Continued)
Safety Features
Ground
Continuity Test:
Programmable: 0.1
Ω
to 5.0
Ω ±
0.2
Ω
Accuracy, or OFF
Ground Fault
Interrupt (GFI):
Shutdown of current imbalance when I > 0.5mA
±
0.25mA, or OFF
In-Rush Current:
DC Mode: Set detection limit: 0.5uA – 5mA in 0.0001mA increments
The programmable range for In-Rush current is dependent on the
programmed High Limit:
Range: High
Limit: In-Rush:
1 0.1
µ
A – 300
µ
A 0.5
µ
A – 300
µ
A
2 0.301mA – 3.000mA 5
µ
A – 3.000mA
3 3.01mA – 5.0mA 50
µ
A – 5.0mA
Fast Output Cutoff: HV output voltage terminated <0.4mS after NG (Fail) result
Fast Discharge:
<0.2s (Typical) Discharge of DUT upon termination of HV.
ARC Detection: Detection Current: Range: 1mA – 20mA AC and 5mA DC
Pulse Width: Minimum: 10
µ
s
General Features
Time: Test*: 0.1sec – 999 sec, Continuous
Ramp: 0.1sec – 999 sec, OFF
Dwell: 0.1sec – 999 sec, OFF (DC & IR Mode only)
Fall: 0.1sec – 999 sec, OFF
* Test Time is limited
≤
60seconds when the voltage and high current limit
>
100VA.
* Test Time for IR is 0.3sec – 999sec, Continuous
Limits: HI/LO programmable during Test Time
LO can be set to OFF during Hipot Test
HI can be set to OFF during IR Test
Indication: Pass/fail LEDs, audible alarm
Remote Control: Inputs: START, STOP
Characteristics: 24V active low, Pulse width
≅
20ms
Outputs: PASS, FAIL, UNDER TEST
Characteristics: Dry contact relay, Closed if true
115V, <100mA
Connector: 9 pin male D-series & Terminal Strip