QuadroM32x Manual I: Installation Guide
Hardware Overview
Hardware Overview
The Connectors Panel of QuadroM32x
The illustration below includes the connectors panel of QuadroM32x.
Fig. I-1: QuadroM32x's Connectors Panels
1 PHONE sockets with RJ11 connectors enable connectivity of regular analog tele-
phones. These are FXS (Foreign Exchange Station) analog ports.
2 The Reset button may be used in two ways: (1) to initiate a normal reset or (2) to car-
ry out a factory reset. A normal reset is executed by pressing the Reset button with a
paper clip for an instant.
Pressing the reset button and holding it down for seven seconds or more will execute
a factory reset. This will restore the factory defaults and clear all settings including
the IP address and the administration password you entered.
Please Note:
A Factory Reset forces the default LAN IP address of 172.30.0.1 and
default admin password of 19.
3 RJ-45 socket to attach the E1/T1 trunk. See
Appendix: Pin Assignment of E1/T1
.
4 ETH RJ45 socket to attach the PC in the Quadro’s Local Area Network (LAN). If a PC
is connected directly to this socket, a straight Ethernet CAT 5 cable is used.
5 LAN RJ45 socket to attach to the IP phones in the Quadro’s Local Area Network
(LAN) via an Ethernet CAT 5 cable. For connecting multiple IP phones, a switch is
used.
6 WAN RJ45 socket to attach the Internet Uplink (WAN) via an Ethernet CAT 5 cable.
7 The CF socket enables connectivity of Compact Flash memory providing expansion
for additional voice mails and record data.
Attention:
Power down the Quadro before inserting/removing the Compact Flash
memory card.
8 Power supply socket. Use only the power adapter delivered with the Quadro.
QuadroM32x; (SW Version 5.2.x)
8
Summary of Contents for QuadroM32x
Page 1: ......