QuadroM32x Manual I: Installation Guide
Step 1: Installing the Quadro
•
Verify the product package contents are complete. Refer to the contents sheet included
in the packaging to determine if all the items were shipped in the box.
•
Before you connect the hardware, make sure that all devices are powered off.
•
Connect analog phones to the PHONE ports on the Quadro’s rear panel. You may
connect up to two analog phones.
•
Connect the E1/T1 port to your PBX or the trunk from the PSTN Central Office ONLY
after configuring the E1/T1 settings according to the specifications of your PSTN pro-
vider (see
Appendix: Pin Assignment of E1/T1
).
•
Connect the Ethernet port on your PC via a straight CAT 5 cable with an RJ45 connec-
tor to the ETH socket of the Quadro.
•
Connect the IP phones to the switch and attach it to the LAN socket of the Quadro via a
straight CAT 5 cable with an RJ45 connector.
•
Connect the WAN port of the Quadro to the Internet service via a cable or DSL modem.
•
Power up the DSL or Cable modem first.
•
Connect the power cable to the POWER port on the back side of your QuadroM32x
and plug the power plug into the power outlet.
The red LED (Fault) will glow for several seconds followed by the yellow LED (Info),
which will glow for several minutes. When Info LED is off, the Quadro is operational.
•
Power up any hub or switch followed by any PC and other devices on the LAN side.
•
Check the LEDs: The green Busy LED must glow continuously. The green ETH, LAN
and WAN LEDs will blink when cables are connected to these ports and all devices are
powered up. If the green LAN and WAN LEDs do not blink, verify cabling and ensure
that all devices are powered up.
Please Note:
CAT 5 cables can be faulty without any visual indication. The ETH, LAN
and WAN LEDs verify that the Ethernet connection is established between the end
points. If these LEDs are not illuminated, there is a connection problem between the
Quadro and the other device.
QuadroM32x; (SW Version 5.2.x)
14
Summary of Contents for QuadroM32x
Page 1: ......
