Quadro6L/4L/2x2 Manual I: Installation Guide
Step 2: Configuring the Quadro
Quadro6L/4L/2x2; (SW Version 5.3.x and higher)
22
DHCP Settings for the LAN Interface
If the DHCP server is enabled, the Quadro will automatically assign dynamic IP addresses
to the stations connected to its LAN port.
If you didn’t change the default LAN IP address of the Quadro, you also may leave the de-
fault values for the
IP Address Range
. Make sure your connected LAN devices belong to
the same network as the LAN port of your Quadro.
Please Note:
Make sure there is only one DHCP server on the LAN, otherwise, unpredict-
able network behavior can occur.
Fig. l- 19: DHCP Settings for the LAN Interface page
Click on
Next
to display the
Regional Settings
Regional Settings
page.
If your Quadro is located outside of the United States, it is important to properly configure
your line connections to the PSTN in your location.
Fig. l- 20: Regional Settings page
Proper configuration of
Regional Settings
is important for the functionality of the voice
subsystem. The Regional Settings determine the proper telephony parameters on the LINE
Summary of Contents for Quadro2x2
Page 1: ......
