Step 5: Complete Header Re-Assembly
Close the upper header over the taped down fabric
sandwiching the fabric but leaving the underside
faced up on the hood (See FIG 29).
Using the screws you removed in step one, reinstall
the four corner screws and then the 19 or 27 (de-
pending on model year) screws along the top of the
header. See FIG 30 & 31.
Un-latch the bow assembly from the windshield
(inside vehicle) and lower the bow assembly to the
rear of the vehicle folding the top back over with the
underside of the fabric facing down (see FIG 32).
Step 6:
Install Over Door Bows to Front Header
Take the Fabric/Header assembly from step five
and place the assembly on a table top or on a soft
towel with the underside facing up and the two
“header legs” facing away from the header (Fig 33).
Locate the over door bow assembly (Fig 34) and
round header sleeve (round tube).
Slip the round
door “sleeve” over the header leg and insert the
“knuckle” installed on the over door bow into the
Header leg (Fig 35).
Making sure the quick release knuckle is facing
outward (Fig 36).
Note that the over door bow assembly are sided-left
and right.
Secure the over door bow to the Header leg with
the attached set screw (Fig 37). Slide the bow
sleeve over the knuckles as shown in Fig 38. Re-
peat this procedure on the opposite side.
The Trusted Source
6
