6
09/20
7050-801E
SANTA FE FREESTANDING
B. Thermostat Wall Control Location
The thermostat wall control’s location will have some affect
on the appliance’s operation.
• Maximum wire length from appliance is 100
feet (30.48m) with continuous non-spliced wire.
Recommended 20 gauge wire, solid copper .
• When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
•
When located in an adjacent room or on a different
floor level, you will notice higher temperatures near
the appliance.
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
•
Follow pipe manufacturer instructions for installation
and air clearance requirements.
C. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
- Reciprocating Saw
-
Channel Locks
- Hammer
-
Phillips Screwdriver
- Tape Measure
-
Plumb Line
-
1/4” Self-Tapping Screws
-
Framing Material
- Hi-temp Caulking Material
- Gloves
- Safety Glasses
-
Framing Square
-
Electric Drill & Bits (1/4”)
-
Level
May also need:
- Vent Support Straps
-
Venting Paint
Risk of Fire!
• Damaged parts could impair
safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
WARNING
Hearth & Home Technologies disclaims
any responsibility for, and the warranty will
be voided by, the following actions:
• Installation and use of any damaged appliance.
•
Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.