R
September 1, 2008
7019-205C
Page 21
Santa Fe Pellet Insert
H. Panel and Trim Set
Access Panels
Open Hopper Lid for
Easier Placement of
Panel Set
Magnet
Hook
View of "L" Bracket
installed
Figure 20.4
Figure 21.2
Figure 21.3
Figure 21.1- Completed View
1. Lay panel top and legs face down on protective cov-
ering to prevent scratching.
1. Attach the panel legs to the top panel using a Phillips
head screwdriver. There are 2 screws for each leg.
Figure 21.2.
2. Open the hopper lid by pulling toward you. This will
make it easier to set the panels in place. Secure the
panels to the insert, 2 screws per leg, as shown in
Figure 21.3.
3. Connect the trim pieces together using the “L” Brack-
ets supplied.
Figure 21.4.
4. Slide the trim over the top of the panels.
5. Install the access panels. At the bottom of the access
panel there are 2 hooks that slip into a slot at the
bottom of the side panel and a magnet at the top that
holds the access panel in place.
Figure 21.3.
Attach panel
legs to top
Back view of panel
Access Panel
Side
Panel
