4. Glass Door
This fireplace has been tested and is intended for use
with doors as supplied with this fireplace.
WARNING!
Risk of Fire and Smoke!
Fireplace should
be operated only with door fully closed. If door is left
partly open, gas and flame may be drawn out of the
fireplace opening.
WARNING!
Fire Risk!
•
Do not use glass door to hold burning material in
fireplace.
• Glass may break or burning material may roll out.
WARNING! RISK OF
Fire! Do NOT install and or use
any component not approved by Hearth & Home Tech-
nologies.
5. Convection Fan Operation
The fireplace is equipped with a temperature-sensitive
snap disc that will turn the convection fan on and off
automatically, depending on the temperature of the fire
-
place.
An override switch and fan speed control have been
installed on the wall in close proximity to the fireplace.
The speed of the fan can be regulated by the speed
control knob.
If the fan is not coming on at the desired time, flip the
override switch to manual and operate the fan as de-
scribed below:
• Initial (cold) Startup
Leave fan off until your fireplace is hot and a good
coal bed is established, approximately 30 minutes
after fuel is lit.
• High Burn Setting
The fan may be left on throughout the burn.
• Medium or Medium High Burn Setting
The fan should be left off until a good burn is
established, then turned on medium or high rate.
• Low Burn Setting
The fan tends to cool off the fireplace. Leave fan off
until the burn is well established; then, if you wish,
turn the fan on at a low rate.
Override Switch
Speed Control
High
Low
Figure 3.7 Override Switch and Fan Speed Control
C. Fuel
WARNING! For use with solid wood fuel only.
Other fuels may overfire and generate poisonous gases (i.e.
carbon monoxide).
This fireplace is designed to burn natural wood only.
Higher efficiencies and lower emissions generally re
-
sult when burning air dried seasoned hardwoods, as
compared to softwoods or to green or freshly cut hard-
woods. DO NOT BURN:
• Garbage
• Lawn clippings or yard waste
• Materials containing rubber, including tires
• Materials containing plastic
• Waste petroleum products, paints or paint thinners,
or asphalt products
• Materials containing asbestos
• Construction or demolition debris
• Railroad ties or pressure-treated wood
• Manure or animal remains
• Salt water driftwood or other previously salt water
saturated materials
• Unseasoned wood
• Paper products, cardboard, plywood, or particleboard.
The prohibition against burning these materials does
not prohibit the use of fire starters made from paper,
cardboard, saw dust, wax and similar substances
for the purpose of starting a fire in an affected wood
heater.
Burning these materials may result in release of toxic
fumes or render the heater ineffective and cause
smoke.
11
Quadra-Fire • Pioneer-II-C Owner’s Manual • 4184-900 • Rev C • 02/20
