16
7038-206F
September 27, 2016
5700 STEP TOP ACC
Included in Kit
: ARS door assembly, ARS latch assembly,
Pedestal, Ash Pedestal Drawer, ARS Channel, ARS Cover,
and fastener package.
Tools Required:
7/16 socket wrench, 3/8 open end wrench,
phillips screw driver, and hammer.
Begin installing the ARS System.
1. Remove leg mount brackets packaged inside of firebox
and discard.
2. Remove the 3 bricks in the front most part of the firebox
(Figure 16.1)
.
3. Lay appliance on its back on a protective pad or pallet
(Figure 16.2)
.
4. Remove heat shield by loosening the four bolts using 3/8
open end wrench
(Figure 16.2)
.
5. Remove 8 nuts that hold the cover plate on using a 7/16
socket wrench; discard cover plate
(Figure 16.2)
.
6. Remove knock out from bottom of firebox by using a
hammer
(Figure 16.2)
.
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side
(Figure 16.3)
.
8. Slide the ash door over the 8 screws protruding from the
bottom of the appliance. Secure with nuts and washers
using 7/16 socket wrench
(
Figure 16.3)
.
9. Install ARS latch by sliding latch assembly over 2 threaded
studs protruding from the bottom on the left hand side of
the appliance. Secure by using two nuts use 7/16 socket
wrench
(Figure 17.1 on page 17)
.
10. Add knob to handle rod (
Figure 17.2 on page 17).
11.
Using two bolts and two flange nuts to secure ARS chan
-
nel using 3/8 open end wrench and 7/16 socket wrench
(Figure 17.3 on page 17).
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
Warning!
5
Appliance Set-Up
Do
NOT
operate before fully assembling components.
Burning your stove without a pedestal or leg kit
attached:
• Will void your warranty.
• May result in property damage or personal injury.
WARNING
NOTE: The Ash Removal System, must be
installed first before installing the pedestal.
A.
Pedestal Assembly and Ash Removal
System (ARS) Installation
Remove 3 bricks for
installation and then re-install
Figure 16.1
Remove
X4
Remove
X8
Cover Plate -
Remove
& discard
Gasket
Knock out
& discard
X
6
4
5
5
7
Heat Shield -
Remove
& discard
4
Figure 16.2
Slot to slide rod of Ash
Door Assembly through
8 threaded
studs
Ash Door
Assembly
Figure 16.3
