Page 50
FR-823122
Février 17, 2004
Quackenbush
Opération et Instructions de Sûreté
Sûreté, Opération Et Service
from the manufacturer. Refer to the appropriate Parts
List Manual for the label numbers and locations.
• Quackenbush drills are designed to operate on
90psig (6.2 bar) air pressure. Excessive air pressure
can increase the loads and stresses on tool parts and
drills, and may result in breakage. The installation of a
filter-regulator-lubricator in the air supply line is
highly recommended.
• Before removing a tool from service or chang-
ing drill bits, make sure the air line is shut off and
drained of air. This will prevent the tool from operating
if the throttle is accidently engaged.
• Cutting tools used with these Quackenbush
drill motors are sharp. Handle them carefully to
avoid injury.
The spindle on right angle positive feed drills retracts
at a much faster rate than it feeds. Care should be
taken to avoid entrapment. Nose pieces usually used
with these drills are generally slotted for visibility and
access to chuck, cutter, and retract stop adjustments.
A spindle guard should be used when operating
tool. Spindle guards in one inch increments are
available to accommodate any length spindle.
Slotted spindle guards are available for tools with
fluid swivels.
Caution
Label
Caution
Label
Caution
Label
AS A REMINDER . . . ALWAYS
w e a r p r o t e c t i v e e q u i p m e n t .
Personal hearing
protection is recom-
mended when oper-
ating or working
near these tools.
Do not wear loose
fitting clothes, long
hair, gloves, ties or
jewelry when operat-
ing or working near
these tools.
Impact resistant eye
protection must be
worn while operat-
ing or working near
these tools.
For Your Safety . . .
For Your Safety . . .