3
FCC Statement
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the power sourcing equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
This device meets FCC and IC requirements for RF exposure in public or uncontrolled environments.
Regulatory information can be viewed from the device display panel. To view in the panel’s Offline state, tap the display to
reveal the Status screen and then navigate to: Status -> Agency. To view in the Online state, enable the ID button in Q-SYS
Designer Software to reveal the Status screen, and then navigate to Status -> Agency.
• TSC-50-G3 contains: FCC ID: 2AGTY-TSC-50-G3 IC: 20383-TSC50G3
• TSC-70-G3 contains: FCC ID: 2AGTY-TSC-70-G3 IC: 20383-TSC70G3
• TSC-101-G3 contains: FCC ID: 2AGTY-TSC-101-G3 IC: 20383-TSC101G3
Image Persistence and Mitigation
LCDs may exhibit image persistence where faint figures from prior displayed content remain visible while new content is displayed
on screen or when the LCD is turned off. This ghosting effect is more likely to occur after displaying bright static content on screen for
long periods of time such as continuously displayed static controls, geometric shapes or text. Image persistence can be minimized
by reducing screen brightness and/or using the Dim Timeout or Off Timeout controls set at short intervals. Selection of colors and
contrasting backgrounds in UCIs may also help to minimize image persistence. In the event that image persistence becomes noticeable,
the effect can be removed by turning the display off for a period of time. The amount of time required depends on the severity of the
effect.
Environmental - Specifications
Expected Product Life Cycle: 10 years, Storage Temperature range: -20C to +70C, Relative Humidity: range of 5
–
85% RH non-
condensing.
NOTE:
TSC-G3 products have been designed and tested to meet safe-touch temperature requirements. However, be aware that these
products may exhibit increased temperatures on accessible enclosure components and may feel warm to the touch during operation.
Environmental - General Compliance
QSC complies with all applicable environmental regulations. This includes (but is not limited to) global environmental laws, such as EU
WEEE Directive (2012/19/EU), China RoHS, Korean RoHS, U.S. Federal and State Environmental Laws and various resource recycling
promotion laws around the world. For more information, visit:
https://www.qsc.com/about-us/green-statement/