QSC DPA-Q, Quick Start Manual

Page: 4 / 11

4
TD-000477-01-A
Parallel Channels (ABCD)
Connect the Loudspeakers (rear panel)
Refer to — Figure 12.
1. Connect the loudspeaker wiring to the 8-pin Euro-style connectors as
needed for your amplifier's configuration.
2. Install the female 8-pin Euro-style connectors onto the male
connector on the rear of the amplifier as shown. Notice that the
Euro-style connectors are facing in opposite directions.
3. Use a Phillips or a flat tip screwdriver to secure the connector.
— Figure 11 —
CHANNEL CONFIGURATION
1 Channel: A B C D
Channel Configuration Locked to Design
Q ABCD
CHANNEL CONFIGURATION
1 Channel: E F G H
Channel Configuration Locked to Design
Q EFGH
CH D
CH A
CH B
CH C
+
+
+
+
-
-
-
-
T8
T5
T6
T7
T4
T1
T2
T3
CH E
CH H
CH G
CH F
+
+
+
+
-
-
-
-
T1
T4
T3
T2
T5
T8
T7
T6
CH ABCD (EFGH)
T3
+
T4
-
OUTPUTS TO SPEAKERS OUTPUTS TO SPEAKERS
For One Loudspeaker
Full power to one loudspeaker
Use one 2-wire cable, connect to:
• T3+/T4- (Loudspeaker A B C D)
For Multiple Loudspeakers
Full power for multiple loudspeakers in parallel
Use up to four 2-wire cables, connect to:
• T1+/T2-(Loudspeaker E)
• T3+/T4-(Loudspeaker F)
• T5+/T6-(Loudspeaker G)
• T7+/T8-(Loudspeaker H)
SETTINGS CAN BE
CONFIGURED FOR
70V, 100V AND
200V DIRECT
OUTPUT.
In 4-1 Parallel (ABCD or EFGH) only
T1+, T3+, T5+, and T7+ are electrically the same point
T2-, T4-, T6-, and T8- are electrically the same point
OUTPUTS TO SPEAKERS OUTPUTS TO SPEAKERS
— Figure 12 —