QSC DPA-Q, Quick Start Manual

Page: 2 / 11

2
TD-000477-01-A
Connections
The following connectors are on the rear panel of the amplifier. Refer to — Figure 2 for location of the connections
discussed in this section.
Q-SYS Q-LAN Connection
Connect the amplifier LAN A and, if a redundant network is available, LAN B, to the Q-LAN network. (—
Figure 3) Refer to your Q-SYS documentation for network requirements and connection detail.
Inputs
The Qn models do not have analog inputs, they get their audio input
exclusively over the Q-LAN Network.
1. Wire the audio line-level source to each Euro-style connector (supplied)
required by your design. You may use either balanced inputs (— Figure 4) or unbalanced inputs (— Figure 5).
2. Plug the connectors into the appropriate receptacles (Routable Inputs 1 through 8) — Figure 6.
TOA ANT!: Do not apply AC power to the amplifier at this time.
3. Make sure the Power Switch is in the off (down position) before
proceeding. (— Figure 7)
4. Connect the IEC power cord to the AC receptacle on the rear of
the amplifier. (— Figure 7)
GPIO
Refer to "GPIO" on page 10 for details about using the GPIO.
— Figure 2 —
CH D
CH A
CH B
CH C
+
+
+
+
-
-
-
-
T8
T5
T6
T7
T4
T1
T2
T3
CH E
CH H
CH G
CH F
+
+
+
+
-
-
-
-
T1
T4
T3
T2
T5
T8
T7
T6
Figure 2 Figure 5 Figure 9 through 12
Figure 7 Figure 6
— Figure 3 — Figure 6
— Figure 9 thru — Figure 12
— Figure 7
— Figure 8
— Figure 3 —
LAN A LAN B
Balanced
— Figure 4 —
—
+
Unbalaced
— Figure 5 —
—
+
— Figure 6 —
ROUTABLE INPUTS
2 1 4 3
6 5 8 7
MIC/LINE
12V Phantom
— Figure 7 —
— Figure 8 —
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16