17 SETTING UP THE BIOLOG 3000
i
The following table highlights the different transtelephonic modes of the
BIOLOG 3000
i
.
Symbol
Meaning
[
DEFAULT MODE: Analog transtelephonic mode is
disabled.
Choose this mode for silence during recording or review.
\
Analog transtelephonic mode is enabled only for the review
or transmission of data. The acquisition of data is silent.
Choose this mode for silence during recording. Sound will
be emitted during review.
]
Analog transtelephonic mode is enabled for the acquisition,
review and transmission of data.
This mode is for transtelephonic transmission of the ECG in
real time to a receiving center. Sound will be emitted during
recording and review.
2.4.4 Automatic Device Identification (ADI)
You can send the serial number of your BIOLOG 3000
i
monitor when
sending a transtelephonic ECG with your BIOLOG 3000
i
to a reception
center equipped with QRS Diagnostic's CardioView software. This
facility is called Automatic Device Identification or ADI in brief.
Turn the ADI ON if sending an ANALOG Transtelephonic recording to
CardioView. Turn ADI OFF if sending an ANALOG Transtelephonic
recording to a non-QRS Diagnostic receiving station.
•
To Select the ADI function, press the HOLD key.
•
To change the setting press the REV key.
2.4.5 Setting the Time
•
To change the time, move the cursor to the appropriate position
(HH for hours or MM for minutes) by pressing the HOLD key (right
arrow) repeatedly.
•
Press the REV key (up arrow) to change to the desired time.
NOTE:
The time is preset in 24-hour format (e.g. 3:30 PM will be shown as 15:30). The factory
setting is Australian Eastern Standard Time.
