QCX assembly Rev 1.08
57
3.59
Install rotary encoder
This switch has seven solder pads: five are for electrical connections and the two large tabs are
for mechanical stability. You may also choose to mount the switch off-board, for example on a
front panel. Refer to the later section describing the wiring. Remember that it will be difficult to
remove the switch later, so you may wish to make the external mounting decision now.
3.60
Install microswitch
The microswitch can be used as an on-
board “straight key” if desired and is suprisingly effective!
The PCB holes are large so be sure to use enough solder to make good joints.
Summary of Contents for QCX 5W CW
