Service Name
Fill in the service name of Service Name. The default
value is empty.
Connection Type
Select the connection type from pull-down menu. There
are
Continuous, Connect on Demand
and
Manual
three types to select.
Continuous
connection type means to setup the
connection through PPPoE protocol whenever this
WLAN AP Router is powered on.
Connect on Demand
connection type means to setup
the connection through PPPoE protocol whenever you
send the data packets out through the WAN interface;
there are a watchdog implemented to close the PPPoE
connection while there are no data sent out longer than
the idle time set.
Manual
connection type means to setup the connection
through the PPPoE protocol by clicking the
Connect
button manually, and clicking the
Disconnect
button
manually.
Idle Time
If you select the
PPPoE
and
Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
MTU Size
Fill in the mtu size of MTU Size. The default value is
1400.
Attain DNS Automatically
Click to select getting DNS address for
DHCP
support.
Please select
Set DNS Manually
if the
DHCP
support is
selected.
Set DNS Manually
Click to select getting DNS address for
DHCP
support.
DNS 1
Fill in the IP address of Domain Name Server 1.
DNS 2
Fill in the IP address of Domain Name Server 2.
DNS 3
Fill in the IP address of Domain Name Server 3.
Clone MAC Address
Fill in the MAC address that is the MAC address to be
cloned.
Enable uPNP
Click the checkbox to enable uPNP function.
Enable IGMP Proxy
Click the checkbox to enable IGMP Proxy.
Enable Ping Access on WAN
Click the checkbox to enable WAN ICMP response.
Enable Web Server Access on WAN
Click the checkbox to enable web configuration from
WAN side.
Enable IPsec pass through on VPN
connection
Click the checkbox to enable IPSec packet pass through.
Enable PPTP pass through on VPN
connection
Click the checkbox to enable PPTP packet pass through.
Enable L2TP pass through on VPN
connection
Click the checkbox to enable L2TP packet pass through.
Apply Changes
Click the
Apply Changes
button to complete the new
configuration setting.
Reset Click
the
Reset
button to abort change and recover the
previous configuration setting.
