CAI-QMINP-01 - QMini Plug Connector Customer Assembly Instructions
Document:
CAI-QMINP-01
Revision:
14
Release Date:
12/08/2014
Revision Date:
10/14/2019
QPC Fiber Optic, LLC
www.qpcfiber.com
27612 El Lazo Road, Laguna Niguel, CA 92677
Ph: (949) 361-8855
Page 9 of 9
Slide the Washer and Cable Seal to the base of the Strain Relief. Slide the Coupling Ring over the Strain
Relief and Connector Body. Place the Plug on the Torque Fixture and hand-tighten the Coupling Ring.
Slide the Backshell into position and hand-tighten it. Torque the Backshell using the Crow’s Foot Wrench
PT-536 with the Dial Torque Measuring Wrench PT-506 to the values in the above Torque Table. Slide the
bend limiter into position and snap into place.
NOTE: For Cable Diameters 7.6mm – 10.5mm
Apply an adhesive (Loctite Stik’N Seal Outdoor Adhesive or similar for rubber applications) on the inside of
the Heat Shrink Bend Limiter. Slide it up towards the Backshell and heat shrink it onto the Backshell
leaving a small gap between the top of the Bend Limiter and the Backshell for the Lanyard.