QNAP Turbo NAS TVS-1271U-RP, Hardware User Manual

Page: 27 / 51

6. Push back top cover. Then fasten the screw.
7. Connect the power adaptor and cables to the NAS.
8. To check that the network expansion is recognized by the NAS, power up the
NAS and login the web interface as an administrator. Go to “Control Panel” >
“System Settings” > “Network” > “TCP/IP” and check the total number of
network interfaces.
8.2 TVS-471
、
TVS-671
、
TVS-871
1. Turn off the NAS. Disconnect the power adaptor, network cable(s), and any other
connectors or cables from the NAS.
2. Before installing the network expansion card, put on an antistatic wrist strap to
prevent electrostatic discharge. The crocodile clip should be connected to the
ground.
3. Remove the top cover as the steps in Chapter 5.1.
4. Loosen the screw and remove the expansion slot cover.