Chapter 7.
Expansion Card Installation
Warning:
1.
The following instructions should only be performed by an authorized and trained
technician.
2.
Strictly adhere to the instructions to install a network expansion card on the NAS.
Failure to do so could result in injury to human body or death.
The TS-x71 series provides expansion slots for network or other expansion.
7.1 TVS-871U- RP
、
TVS-1271U- RP:
1.
Turn off the NAS. Disconnect the power adaptor, network cable(s), and any
other connectors or cables from the NAS.
2.
Before installing the network expansion card, put on an antistatic wrist strap to
prevent electrostatic discharge. The crocodile clip should be connected to the
ground.
3.
Remove the top cover as the steps in Chapter 5.1.
4.
Loosen the screw and remove the expansion slot cover.
5.
Insert the expansion card to the PCIe slot until it cannot go any further. Then
fasten the screw.
Summary of Contents for Turbo NAS TVS-1271U-RP
Page 1: ...QNAP Turbo NAS TVS x71 Series Hardware User Manual 2014 QNAP Systems Inc All Rights Reserved ...
Page 13: ...http www qnap com for details ...
Page 25: ...3 Press insert the module fixing 4 Replace the cover and tighten the rear screws ...
Page 35: ...3 Unplug the failed power supply 4 Plug in a new power supply to the NAS 5 Turn on the NAS ...
