QNAP Turbo NAS TVS-1271U-RP, Hardware User Manual

Page: 19 / 51

Chapter 5. Upgrade Memory on QNAP Turbo NAS (RAM Module
Installation)
Warning:

The following instructions should only be performed by an authorized and trained
technician.

Strictly adhere to the instructions to install a RAM module on the NAS. Failure to do
so could result in injury to human body or death.
QNAP provides RAM module (optional purchase) for users to upgrade the memory of the
NAS. Insert an extra RAM module on the motherboard of the NAS to upgrade the memory.
The total memory will be shown in “System Information” of the administration page.
5.1 TVS-871U- RP
、
TVS-1271U- RP
1. Follow the steps below to install a RAM module on the NAS.
2.
Turn off the NAS. Disconnect the power adaptor, network cable(s), and any other
connectors or cables from the NAS.
3.
Before installing the memory module, put on an antistatic wrist strap to prevent
electrostatic discharge. The crocodile clip should be connected to the ground.
4. Remove the top cover.
Loosen the 2 screws on the rear of the NAS as shown in the
illustration.
5.
Hold the notch at the edge of the top cover. Remove the top cover in both hands.