97
System
Support
s
3.5-inch
SATA
Hard
Drives
Support
s
2.5-inch
SATA
Hard
Drives
Suppor
ts
2.5”
SATA
SSD
Supports
M.2 SATA
SSD
Supports
Hot-swappin
g Hard
Drives
(RAID 1 or
above only)
Pro, TS-853S Pro,
IS-453S
TBS-453A
✔
(2280,
2260, 2242)
The NAS supports hot-swapping the hard drives when 1 member drive crashes in RAID 1,
1–2 member drives crash in RAID 5 or RAID 6. Follow the steps below to hot-swap the hard
drive when a member drive fails in a RAID configuration.
1.
Login the NAS and check the disk volume configuration in “Volume Management”.
2.
The volume status should be “in degraded mode”.
3.
Prepare a new hard drive to replace the failed one. The capacity of the new hard drive
should be the same as or larger than the failed hard drive.
4.
Unplug the failed drive from the NAS. Wait for about 20 seconds or until the server
beeps twice.
5.
Remove the failed drive from the drive tray.
6.
Install the new hard drive on the drive tray. Insert it to the NAS.
7.
The server should beep 1.5 seconds twice.
8.
Check the volume status on the web administration page. The volume should be
rebuilding.
Warning:
Users are strongly recommended to turn OFF the server before replacing
the hard drive to reduce the risk of electric shock.
