107
TCP/IP
In TCP/IP, you can see the following options:
1.
LAN IP Address
2.
LAN Subnet Mask
3.
LAN Gateway
4.
LAN PRI. DNS
5.
LAN SEC. DNS
(You can view the above settings for every interface. )
6.
Enter Network Settings
a.
Network Settings – DHCP
i.
Set up DHCP on LAN1 and LAN2.
b.
Network Settings – Static IP*
i.
Press “SELECT” to switch to the next available option.
ii.
Press “ENTER” to configure the selected option. The first digit will begin to blink.
iii.
Press “SELECT” to increment the selected digit, press “ENTER” to confirm the value,
and go to the next digit until all digits are set.
iv.
Repeat this procedure this for every setting you want to change.
c.
Network Settings – BACK
7.
Back to Main Menu
* In this section, you can only configure IP address, subnet mask, gateway, and DNS of
LAN1 and LAN2.
Physical disk
In Physical disk, you can view the following options:
1. Disk Info
2. Back to Main Menu
Disk Info shows the temperature and the capacity of each hard drive.
