Qlogic SANsurfer FC/CNA HBA CLI, User Manual, Page: 220 / 348

4–Non-Interactive Commands
Command Summary
4-46 SN0054614-00 K
To show the target information for a specific target on a specific adapter, type:
-t (< hba instance > | < hba wwpn >) (< target wwpn > | < target port
id >)
iiDMA (intelligent interleaved direct memory access) settings include:
„
—targets | –t
applies to all targets.
„
<speed>
indicates the supported intelligent interleave factor: 1, 2, 4, or 8
Gbps.
-tb
(Target Beacon On/Off)
To start or stop flashing a target’s LED, type:
# scli -tb (< hba instance > | < hba wwpn >) (< target wwpn >)
(<0 | ON> | <1 | PRESET>)
-tp
(Display Host Topology)
Use the
-tp
option to show the topology configuration of the host:
# scli -tp | topology
Under Linux, this feature is disabled if you are using the IOCTL or sysfs (inbox)
driver.
“Host Topology (Command Line Option -tp)” on page 4-3 covers this command.
-u
(Firmware Area Update/Save)
Use the
-u
option to update the firmware preload area of the adapter from a
DAT
file or to save the current firmware preload area of the adapter to a
DAT
file.
To update the adapter firmware preload table, enter the following command:
# scli -u ( < hba instance > | < hba wwpn > ) < file name >
NOTE:
„ The
<0 | ON>
option flashes the LED until interrupted. The
<1 |
PRESET>
option flashes the LED 12 times.
„ This feature is supported only on JBOD (“just a bunch of disks”) devices.
NOTE:
This option is available only for 8Gb adapters.