Qlogic SANbox 5600 Series, Installation Manual

Page: 197 / 280

B – Command Line Interface
Set Config Command
59096-02 C B-75
A
The following is an example of the Set Config Zoning command.
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
InteropAutoSave (True / False) [True]
DefaultVisibility (All / None) [All ]
DiscardInactive (True / False) [False]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.