Qlogic SANbox 5600 Series, Installation Manual

Page: 187 / 280

B – Command Line Interface
Set Config Command
59096-02 C B-65
A
LinkSpeed Transmission speed:
„
1/2/4-Gbps Ports: 1-Gbps, 2-Gbps, 4-Gbps, or Auto. The
default is Auto.
„
10-Gbps Ports: 10-Gbps
PortType Port type:
„
1/2/4-Gbps Ports: GL, G, F, FL, Donor. The default is GL.
„
10-Gbps Ports: G
SymbolicPortName Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is Port n where n is the port number.
ALFairness
(1/2/4-Gbps ports only) Arbitration loop fairness. Enables (True) or disables (False)
the switch’s priority to arbitrate on the loop. The default is
False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the con-
nected device for FC-4 descriptor information during login.
The default is True.
ForceOfflineRSCN Enables (False) or disables (True) the immediate transmis-
sion of RSCN messages when communication between a
port and a device is interrupted. If enabled, the RSCN mes-
sage is delayed for 200 ms for locally attached devices and
400 ms for devices connected through other switches. The
default is False. This parameter is ignored if IOStreamGuard
is enabled.
ARB_FF
(1/2/4-Gbps ports only) Send ARB_FF (True) instead of IDLEs (False) on the loop.
The default is False.
InteropCredit Interoperability credit. The number of buffer-to-buffer credits
per port. 0 means the default (16) is unchanged. Changing
interoperability credits is necessary only for E_Ports that are
connected to non-FC-SW-2-compliant switches. Contact your
authorized maintenance provider for assistance in using this
feature.
ExtCredit
(1/2/4-Gbps ports only) Extended credits. The number of port buffer credits that this
port can acquire from donor ports. The default is 0.
FANEnable
(1/2/4-Gbps ports only) Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The default
is True.
Table B-18. Set Config Port Parameters (Continued)
Parameter Description