Qlogic SANbox 5600 Series, Installation Manual

Page: 128 / 280

B – Command Line Interface
Commands
B-6 59096-02 C
S
B.4
Commands
The command syntax is as follows:
command
keyword
keyword
[value]
keyword [value1] [value2]
The Command is followed by one or more keywords. Consider the following rules
and conventions:
„
Commands and keywords are case insensitive.
„
Required keyword values appear in standard font: [value]. Optional values
are shown in italics:
[value].
„
Underlined portions of the keyword in the command format indicate the
abbreviated form that can be used. For example the Delete keyword can be
abbreviated Del.
The command-line completion feature makes entering and repeating commands
easier.
Table B-1 describes the command-line completion keystrokes.
The command set performs monitoring and configuration tasks. Commands
related to monitoring tasks are available to all account names. Commands related
to configuration tasks are available only within an admin session. An account
must have Admin authority to enter the Admin Start command, which opens an
admin session. Refer to the
”Admin Command” on page B-8 .
The commands and their page numbers are listed in Table B-2 .
Table B-1. Command-Line Completion
Keystroke Effect
Tab Completes the command line. Enter at least one character and press
the tab key to complete the command line. If more than one possibility
exists, press the Tab key again to display all possibilities.
Up Arrow Scrolls backward through the list of previously entered commands.
Down Arrow Scrolls forward through the list of previously entered commands.
Control-A Moves the cursor to the beginning of the command line
Control-E Moves the cursor to the end of the command line.